Program Download
D062/D063/D065/D066 6-6 SM
6.4 PROGRAM DOWNLOAD
Here are some important points to keep in mind when downloading software:
If an error interrupts download processing, the machine cannot operate normally with
the program software only partially downloaded.
When download processing execution starts, a progress bar (“***____”) is displayed
until the download completes successfully.
If the download is interrupted while the asterisks are displayed, the machine does not
attempt a re-try.
The program that downloads firmware from an SD card is part of the GW controller
software. If downloading this software is interrupted, the program stored in the
machine may become corrupted. If this occurs, it may not be possible to restart the
downloading program.
If the GW controller software cannot be downloaded, software on other SD cards
cannot be downloaded as well.
If such problems occur, it may be possible to restart the program without replacing the
controller board by setting controller DIP SW 1 to ON and then re-starting.
6.4.1 RECOVERY METHODS
When an error occurs during downloading, an error code is displayed on the operation
panel.
If the download procedure can be re-started, re-start the download procedure.
If the download procedure cannot be downloaded for other than the GW controller,
replace the board where the downloaded program is stored.
If the download procedure cannot be downloaded for the GW controller, power the
machine off and on to start the downloading program.
6.4.2 DOWNLOAD ERROR CODES
Display Details Recovery
01
Reboot after card
insert E01
Module ID Card No.
Controller ROM update error 1
Use the correct
card
When the update break data is
⇒
Rev. 11/17/2011
To Next Page
Loading...
Need help?
General
