Service Program Mode
SM 5-3 D062/D063/D065/D066
System
Maintenance
Press to enter the setting. (If you enter a number that is out of range, the key
press is ignored.)
When you are prompted to complete the selection, press Yes.
6. If you need to perform a test print, press Copy Window to open the copy window and
select the settings for the test print. Press Start
twice, then press SP Mode
(highlighted) in the copy window to return to the SP mode display.
7. When you are finished, press Exit twice to return to the copy window.
5.1.5 SP MODE BUTTON SUMMARY
Here is a short summary of the touch-panel buttons.
(1): Open All.
Opens all SP groups and sublevels.
(2): Close All.
Closes all open groups and sublevels and restores the initial SP mode display.
(3): Copy Window.
Opens the copy window (copy mode) so you can make test copies. To return to the SP
mode screen, press SP Mode (highlighted) in the copy window.
(4): SP Direct.
Enter the SP code directly with the number keys if you know the SP number, then press
.
(SP Direct must be highlighted before you can enter the number. Just press SP Direct if it is
not highlighted.)
(5): Exit.
Press twice to leave the SP mode and return to the copy window to resume normal
operation.
(6): SPnxxx.
Press any group number to open a list of SP codes and titles for that group. For example,
to open the SP code list for SP1-nnn, press SP1XXX. If an SP has sublevels, it is marked
To Next Page
Loading...
Need help?
General
