System SP Tables-5
D017/D018/D019/D020/D084/D085 4-142 SM Appendix
5985
Device Setting
The NIC and USB support features are built into the GW controller. In order to
use the NIC and USB functions built into the controller board, these SP codes
must be set to "1" (Default: 1 Enabled)
1 On Board NIC
0: Disable, 1: Enable
2 On Board USB
5987
Mech. Counter
This SP detects that a mechanical counter device is removed. If it is
detected, SC610 occurs.
0: OFF. 1: ON
5990
SP Print Mode (SMC Print)
In the SP mode, press Copy Window to move to the copy screen, select the
paper size, then press Start. Select A4/LT (Sideways) or larger to ensure
that all the information prints. Press SP Window to return to the SP mode,
select the desired print, and press Execute.
1 All (Data List)
2 SP (Mode Data List)
3 User Program
4 Logging Data
5 Diagnostic Report
6 Non-Default (Prints only SPs set to values other than defaults.)
7 NIB Summary
8 Capture Log
To Next Page
Loading...
Need help?
General
