Programming and Operating Manual (Turning)
01/2017
47
Correcting a part program
As soon as a syntax error in the part program is detected by the control system, program execution is interrupted and the
syntax error is displayed in the alarm line. In this case, you can correct the error directly in the machining operating area with
the program correction function. When making program changes, the control system must be brought into the reset state.
Note
The program correction function is not available for program execution from external.
Prerequisite: A part program is loaded in "AUTO" mode in the machining operating area.
Press this key on the MCP to place the pro
gram in the reset mode.
activate the block editing window.
Make the necessary corrections. Any changes to the program will be stored immediately.
After you finish the program correction, press this softkey to switch back to the block di
s
Press this key on the MCP to restart the machining of the program.
Simultaneous recording during machining of the workpiece
You can follow machining of the workpiece on the screen while the program is being executed on the machine.
Select the program management operating area.
Enter the target program directory and position the cursor on the desired program.
Press this softkey and the system automatically changes to "AUTO" mode in the machining
operating area.
Press this softkey to open the simultaneous recording window.
Press this key to start the recording. The machi
ning of the workpiece is started and graph-
ically displayed on the screen.
To Next Page
Loading...
Need help?
General
