Siemens SINUMERIK User Manual

Programming and Operating Manual (Turning)
64 01/2017
5.
Press this softkey and the system automatically switches to "AUTO" mode in the machining
operating area. The program is transfe
rred to the buffer memory on the control system and
then displayed in the following window:
6.
If
desired, you can use this softkey to specify how you want the program to be executed.
For more information of the program control, refer to Section "
Program control functions
(Page
51)" .
7.
Pre
ss this key to execute the program. The program is reloaded continuously.
Either at the end of the program or after pressing this key, the program is autom
atically
removed from the control system.
10.7.2.3
Transferring from external (through Ethernet connection)
Prerequisites:
● An Ethernet connection has been established between the control system and the computer.
● A network drive (which includes the part program to be transferred) has been created and connected.
Proceed as follows to transfer a part program from external through the Ethernet connection:
1.
Select the program management operating area.
2.
Press this softkey to view the network drive(s) created.
3.
Select the desired network drive (which includes the part program to be transfe
rred) and
press this key to open it.
4.
Select the program file you desire to transfer.
5.
Press this softkey to copy the file to the buffer memory on the control system.
6.
Enter the program directory.
7.
Press this softkey to paste the copied file into the program directory.

Siemens SINUMERIK Specifications

General

Brand	Siemens
Model	SINUMERIK
Category	Control Unit
Language	English