Siemens SINUMERIK User Manual

Programming and Operating Manual (Turning)
60 01/2017
3.
To directly execute the program, press this softkey
. The system automatically switches to
"AUTO" mode in the machining operating area. The program is transferred to the buffer
memory on the control system and then displayed in the following window:
You can also press this key on the PPU to view the program blocks first before executing.
Then press the following softkey to execute:
4.
If desired, you can use this softkey to specify how you want the program to be executed.
For more information
of the program control, refer to Section "Program control functions
(Page 51)".
5.
Press this key to execute the program. The program is reloaded continuously.
Either at the end of the program or after pressing this key, the program is autom
atically
removed from the control system.
Note
The USB directory is automatically identified if a USB stick is inserted.
Do not remove the USB stick during the external program execution through the USB interface.
10.7.1.2
Transferring from external (through USB interface)
Prerequisite:
A USB memory stick (which includes the part program to be transferred) is inserted in the front USB interface
of the PPU.
Proceed as follows to transfer a part program from external through the USB interface:
1.
Select the program management operating area.
2.
Press this softkey to enter the USB directory.
3.
Select the program file you desire to transfer.
4.
Press t
his softkey to copy the file to the buffer memory on the control system.
5.
Enter the program directory.
6.
Press this softkey to paste the copied file into the program directory.

Siemens SINUMERIK Specifications

General

Brand	Siemens
Model	SINUMERIK
Category	Control Unit
Language	English