Name: Toyota 1HZ
Brand: Toyota
Rating: 4 (1 reviews)

To Next Page

To Previous Page

FUEL SYSTEM Injection Pump FU-59

If the thrust clearance is not as specified, adjust with a

governor gear adjusting washer.

Governor gear adjusting washer thickness:

1.05 mm (0.0413 in.)

1.25 mm (0.0492 in.)

1.45 mm (0.0571 in.)

1.65 mm (0.0650 in.)

1.85 mm (0.0728 in.)

21. ADJUST PROTRUSION OF GOVERNOR SHAFT

(a) Using vernier calipers, measure the protrusion of the

governor shaft.

Protrusion: 0.5-2.0 mm (0.020-0.079 in.)

If the protrusion is not as specified, adjust by turning the

governor shaft.

(b) Install and tighten the nut while holding the governor

shaft with a 5 mm hexagon wrench.

22. (1 PZ (w/ HAC) and 1 HZ (w/ HAC))

ASSEMBLE HIGH ALTITUDE COMPENSATOR

Install control lever

(a) Insert the connecting pin into governor cover.

(b) Using a small screwdriver, install the control lever with

the support pin.

Questions and Answers:

Need help?

Do you have a question about the Toyota 1HZ and is the answer not in the manual?

Toyota 1HZ Specifications

General