REFERENCE
5--44 27080 Issue 1 August 98
Backup Printer
This function down--loads the printer settings onto a specially
formatted PCMCIA card, to provide a back--up record of the printer
configuration. Thecardcanthenbeheldforuseinrestoringthesettings
in the printer after repair, or setting up another printer for similar
operation.
CAUTION ElectroStatic Discharge precautions must ALWAYS
be taken when entering the electronics compartment
to avoid damage tothecomponents. Aground/earth
chassis connector is provided for connection of a
wrist strap.
To back--up the printer configuration, switch the printeronand(while
wearing a wrist strap) plug in the back--up/restore card, enter the
Service topic menu and select back--up printer.
Torestorethesettings,(wearingawriststrap)fitthePCMCIAcardinto
the printer while shut down and then start up the printer. The screen
will identify a function key with the label Restore and if selected, two
function keys will then be labled Yes and No, allowing the reload to
continue or be terminated.
Product Sequence Simulation
Permits internal product detection
by setting up a simulated product
detect sequence. This can can be
limited to a specified number of
products or, if set to continuous,
allowedtorun untilstoppedbythe
operator.
A message identifies the current product detectorsource as internalor
external (see External I/F pg. 5--41).
Number of Products: Enter 0--65536 products to be simulated.
Product Pitch: Enter 0--65536 strokes as distance between
start of one product and start of next.
Product Length: Enter 0--65536 strokes as distance from start
to end of product.
Function key options:
Exit: Return to Internal Product Detector.
Start Sequence: Starts the simulation as a sequence running
up to the Number of Products.
Start Cont: Starts the simulation as a continuous
sequence, not limited to the Number of
Products. Continues until Stop is used.
Stop: Stops the simulation.
External
I/F
To Next Page
Loading...
Need help?
General
