DISPLAY MESSAGES AND FAULT FINDING
27080 Issue 1 August 98 4--17
PRINTER FAULTS
The following problems can have the suggested causes and remedies.
No Indicators Showing
Power failure.
Restore power.
Fuse failure.
Replace fuse (see pg. 8--22).
Machine Does Not Print
Message faulty.
Check data entry.
Product detector disconnected or faulty.
Check detector.
Width control set too low.
Reset width control.
Faulty Shaft Encoder.
Check shaft encoder and connector.
External stroke source selected (where no encoder is fitted).
Change to internal stroke source (see pg. 5--42).
Print Position Incorrect
Print delay incorrect.
Re--enter Print delay data.
Product detector misaligned.
Re--align detector.
Spaces entered at start or end of message.
Clear fixed spaces from input data.
To Next Page
Loading...
Need help?
General
