OPTIONS
27080 Issue 1 Sept 98 10--5
ALARM BEACON
The beacon assembly consists of:
D A beacon, which can be mounted up to 2 metres from the printer.
D A beacon connector assembly.
The beacon consists of a short tubular aluminium pole carrying three
lamps in ”totem pole” style, with a mounting bracket and a 2 metre
cable. The beacon indicators are as follows:
Green (non--flashing) -- printer is printing or ready to print.
Red (flashing) -- there is a fault, printer has stopped.
Amber (flashing) -- printer requires attention.
Thebeaconisconnectedintothebeaconconnectorassemblyontheside
of the cabinet.
Installation
The printer must be shut down and the power removed.
(1) Install the cable assembly beacon port into the cabinet (see
pg.10--6).
Thebeaconmountingbracketisshowninthediagram. Thebeaconcan
be mounted within its 2m cable length. Mounting holes are provided
at the rear right hand side of the printer, if required.
(2) Fit the beacon cable connector into the cabinet connector.
Bulb Replacement
Disconnect the beacon connector from the printer cabinet.
(1) Remove the relevant coloured lamp cover (these are bayonet
fixings).
(2) Remove thelampunitbysqueezingthebottom ofthe lamp unitto
freethetabs, andpullfreeoftheothers. The bulbis housedinside
and has a bayonet fitting.
(3) To replacethe lamp unit, ensure that it is in the correct orientation
and push onto the other lamp units.
(4) Refit the lamp cover.
To replace the Beacon fitting kit (housing the flasher unit), remove all
the lamp units and covers and fit to the new beacon fitting kit.
To Next Page
Loading...
Need help?
General
