6-41
Table 6-2.
Mass ProPlate Sensor Limits.
Sensor Trim Procedure (For Bench Calibration)
1. Trim Absolute Pressure Offset (zero).
a. Select M
aintenance, Sensor Trim to display the Sensor
Trim screen.
b. Select Absolute Press then select Offset & Slope Trim. Set
Offset Trim Poin
t and units, set Slope Trim Point and units,
then select T
rim to display the “Sensor Offset Trim” screen.
Figure 6-41.
Sensor Offset Trim Screen.
Sensor LRL URL
DP Range 2
±LQ+
DW) LQ+
DW)
DP Range 3
±LQ+
DW) LQ+
DW)
AP Range 3 / GP Range C
SVLDSVLJ SVLDSVLJ
AP Range 4 / GP Range D
SVLDSVLJ SVLDSVLJ
PT
±)±& )&
Figure 6-40.
Sensor Trim Screen.
To Next Page
Loading...
Need help?
General
