Rosemount Model 1195/ProPlate/Mass ProPlate
1-2
Section 4: Commissioning describes how to commission direct
mounted and remote mounted ProPlates and Mass ProPlates after
installation.
Section 5: Electronics Functions provides information for
commissioning the electronics, including operation of the software
functions, configuration parameters, and on-line variables of the
ProPlate or Mass ProPlate.
Section 6: Using the Mass ProPlate Engineering Assistant
Software describes how to use the configuration software, including
installing the software onto a PC, establishing communications with
the Mass ProPlate, configuring the Mass ProPlate, creating a
configuration file, and calibrating the Mass ProPlate. This section also
explains the configuration software menus.
Section 7: LCD Meter Options provides information about
installation options on ProPlate and Mass ProPlate.
Section 8: Maintenance explains maintenance on the primary flow
element.
Section 9: Troubleshooting provides troubleshooting techniques for
common operating problems associated with ProPlate and Mass
ProPlate and provides information on how to wire your integral or
remote RTD and maintenance for integral RTDs.
Section 10: Specifications and Reference Data provides
specification and reference data for the Model 1195, ProPlate, and Mass
ProPlate.
Appendix A: HART Communicator contains a communicator
overview, a HART communicator menu tree for the ProPlate and Mass
ProPlate, and a table of diagnostic messages associated with the
communicator.
Appendix B: Process Configuration Data Sheets shows forms
used to identify important physical specifications about the process and
the Model 1195, ProPlate, or Mass ProPlate.
Appendix C: Calculation Data Sheets shows examples of
calculation data sheets that can be generated and shipped directly to
the customer once a completed Process Configuration Data Sheet has
been submitted to Dieterich Standard, Inc. or Rosemount Inc. for the
Model 1195, ProPlate, or Mass ProPlate.
Appendix D: Approval Drawings illustrates Factory Mutual (FM)
and Canadian Standards Association (CSA) certified drawings.
Appendix E: Spare Parts
contains a table of spare parts available for ordering.
INSTALLATION
FLOWCHART AND
CHECKLIST
Figure 1-1 shows an installation flowchart to provide guidance through
the installation process. Following the figure, an installation checklist
has been provided to verify that all critical steps have been taken in the
installation process. The checklist numbers are indicated in the
flowchart.
To Next Page
Loading...
Need help?
General
