4 - 59
4.7 Output (Y) Status Setting for Switching STOP to RUN
4
FUNCTIONS
(4) Setting of output (Y) status when switching STOP to RUN status
On the <<System setting>> tab of the C Controller setting utility, set the output status
before STOP when the STOP status has been changed to RUN.
(5) Precautions
(a) When the output (Y) was forcibly turned ON in the STOP status
The following explains how the output (Y) operates when it is forcibly turned ON
with the C Controller module set in STOP status and then the status is changed
from STOP to RUN.
Figure 4.45 Output mode setting at STOP to RUN
Output mode
setting when
switching from
STOP to RUN
To Next Page
Loading...
Need help?
General
