• Corner turntable lifts
• Travelling trolleys
Commission tool
It is recommended that you commission the conveyor control function using the Startdrive
PC tool or the SINAMICS G120 Smart Access.
Commissioning tools (Page106)
Note
All screenshots in Chapter "Conveyor technology control functions" take the converter with
PROFINET interface by using the Startdrive PC tool as examples. You can also commission the
functions via the SINAMICS G120 Smart Access. For more information, see Section "Application
setup" in the SINAMICS G120 Smart Access Operating Instructions.
Overview of the manuals (Page588)
7.9.1 Conveyors
Conveyors move materials from one location to another. There are dierent types of conveyors
(for example, roller conveyors, chain conveyors, or belt conveyors) available for use according
to your particular applications.
7.9.1.1 Conveyor, one direction and one speed (p3393 = 1)
Overview
With p3393 (conveyor technology application) set to 1, the converter enables the load on a
conveyor belt to move in one direction with a xed speed. A sensor is required to signal the limit
position for the motor to stop.
Advanced commissioning
7.9Conveyor technology control functions (for G115D PROFINET and AS-i variants only)
SINAMICS G115D Wall Mounted distributed drive
186 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA
To Next Page
Loading...
Need help?
General