Parameters
Conveyor technology control parameters (Page220)
7.9.5 Conveyor technology control parameters
Parameter Description Setting
r0722.0...25 CO/BO: Digital inputs status Interconnect the signals of the sensors to the digi‐
tal inputs as desired.
p1070[0...n] CI: Main setpoint Sets the signal source for the main setpoint.
p1071[0...n] CI: Main setpoint scaling Sets the signal source for scaling the main setpoint.
Factory setting: 1
p1075[0...n] CI: Supplementary setpoint Sets the signal source for the supplementary set‐
point. Note that the supplementary setpoint adds
to both p3397 and p3398
Advanced commissioning
7.9Conveyor technology control functions (for G115D PROFINET and AS-i variants only)
SINAMICS G115D Wall Mounted distributed drive
220 Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA
To Next Page
Loading...
Need help?
General