8.2.2 PG/PC → converter
You can transfer parameter settings from a PG/PC to the converter by the following method:
• Transfer with Startdrive
• Transfer with SINAMICS G120 Smart Access
Transferring using Startdrive
Precondition
• Connection between the PG/PC and converter has been properly established via a USB cable
or the eldbus.
• You have installed the Startdrive commissioning tool on your PG/PC.
The procedure depends on whether you also transfer settings of safety functions or not.
Procedure with Startdrive without enabled safety functions
1. Go online.
2. Proceed as follows to transfer settings from the PG/PC to the converter:
3. Wait until Startdrive prompts that the transfer procedure is complete.
4. Go oine.
You have transferred the settings from the PG/PC to the converter with Startdrive.
❒
Procedure with Startdrive when the safety functions are enabled
Data backup and series commissioning
8.2Transferring settings using a PG/PC
SINAMICS G115D Wall Mounted distributed drive
Operating Instructions, 07/2023, FW V4.7 SP14, A5E52808211A AA 359
To Next Page
Loading...
Need help?
General