Siemens SINUMERIK 808D ADVANCED Series User Manual

Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
259
13.5.7
Transferring the desired files to the control system
Proceed as follows to transfer the required files to the control system.
Prerequisite:
A USB memory stick which contains all required files is inserted into the USB interface at the front of the PPU.
Transferring the user cycle file
+
1.
Select the system data operating area.
2.
Open the USB storage directory through the following softkey operations:
→
3.
Select the desired user cycle file (for example, CYCLE100.SPF) and then press this softkey
to copy the file.
4.
Press this softkey to open the user cycle directory.
5.
Press this softkey to paste the file.
Transferring the bitmap file
1.
Press this softkey to switch to the USB storage di
rectory.
2.
Select the desired bitmap file(s) (for example, cn1.bmp, cn2.bmp...) and then press this
softkey to copy the file(s).
Note that you can use the follo
wing key to select multiple files:
3.
Press this softkey to open th
e window of system data.
4.
Find the folder for storing the user cycle files through the following operations, and press
this key to open it:
→ →
5.
Press this key to open the following user cycle bitmap file folder:

Siemens SINUMERIK 808D ADVANCED Series Specifications

General

Brand	Siemens
Model	SINUMERIK 808D ADVANCED Series
Category	Control Unit
Language	English