Chapter 18 System Setup (System)
1061
Installation and Device Setup (Install/Unit Config Menu)
OK: Installation already completed.
On: For installation, but not completed.
Error: An error occurred during installation.
Cancel: Installation canceled.
Lower list: For the device selected in the upper list, this shows an
automatically detected list of software that can be installed on the
particular device. Also, software selected as a candidate for
installation in the upper list is marked in the lower list with an bullet.
3
If you are satisfied with the currently installed version of all items in the
upper list, skip to step 6.
To change the items to be installed, use any of the following methods to
select the relevant device.
• Press directly on the list in the status area.
• Use the arrow keys to scroll the reverse video cursor.
• Turn the knob.
The display of the lower list changes according to the selected device.
To display all related software
Press [Display All Software], turning it on.
Not just the automatically detected software, but the names of all related
software for the selected device appear.
4
In the lower list, select the software you want to install.
• Press directly on the list in the status area.
• Use the arrow keys to scroll the reverse video cursor.
• Turn the knob.
5
Press [Set].
The selection is reflected under “Install” and “Title” in the upper list.
6
Press [Install].
The “Install” box shows “On,” confirming that this is to be installed. To
cancel this installation setting, press “Install” once more, making the box
blank.
7
Repeat steps 3 to 6, to confirm all software to be installed.
Knob Parameter Adjustment Setting values
1 Device Device selection 1 and upwards
Knob Parameter Adjustment Setting values
3 No Software selection 1 and upwards
To Next Page
Loading...
Need help?
General