Chapter 11 DME Operations
637
DME Special Effect Operations
m
In the state corresponding to image 2, if you switch [Effect Gp2] to On, then
the mask should be applied to portion 2 only, but in fact the border or beveled
edge is also masked.
Freeze Settings
Freezes the input video. The following types are available:
Hard Freeze: Freezes the input video at an arbitrary timing.
Time Strobe: Freezes the input video at specified intervals for a specified
length.
Film: Slows the apparent frame rate, for an effect like film. You can specify
the ratio of advancement.
For Hard Freeze and Time Strobe, you can select the first field or the frame as
the freeze timing.
Notes
When 720P or 1080P signal format is used, the Film mode cannot be selected.
To apply a Freeze effect, start by displaying the Freeze menu. In the DME
menu, select VF3 ‘Freeze’ and HF1 ‘Freeze.’
Image 2: State with [Effect Gp1] only set to On
Portion 2 has ‘Mono’
masked, and ‘Defocus’
only applied.
Portion 1 has both
‘Mono’ and ‘Defocus’
applied.
Image 3: State with [Effect Gp1] and [Effect Gp2] set to On
The border or beveled
edge effect is also
masked.
To Next Page
Loading...
Need help?
General