Chapter 19 Control Panel Setup (Panel)
1120
Cross-Point Settings (Xpt Assign Menu)
Notes
The contents of a sub table cannot be copied to the main table.
1
In the Panel >Xpt Assign menu, press [Table Copy].
The Table Copy menu appears.
The status area shows a list of copy sources and a list of copy destinations.
2
Using any of the following methods, select the number of the table to use
as the copy source and the number of the table you want to be the copy
destination.
• Press directly on the list of copy sources (left-side list) or the list of copy
destinations (right-side list) in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
Press [Copy].
A confirmation message appears, asking whether or not to execute the
copy.
4
To execute the copy, press [Yes], and to cancel the operation, press [No].
Selecting Cross-Point Assign Tables
You can select the cross-point assign table to be used for each of the following
banks or buses.
• M/E-1 to M/E-4 banks and PGM/PST bank
• Buses assignable to AUX delegation buttons
Notes
It is not possible to assign cross-point tables 5 to 14 to a bus of a switcher
operated by an MKS-8080/8082 AUX Bus Remote Panel.
1
In the Panel >Xpt Assign menu, using any of the following methods, select
the switcher bank or bus.
• Press directly on the list on the left of the status area.
• Press the arrow keys on the list on the left to scroll the reverse video
cursor.
Knob Parameter Adjustment Setting values
1 Left No Selection of copy source 1 to 15
2 Right No Selection of copy destination 1 to 14
To Next Page
Loading...
Need help?
General