Chapter 15 Utility/Shotbox
897
Shotbox Execution
1
Press one of the bank selection buttons [BANK1] to [BANK4] to select the
bank.
• The pressed bank selection button lights amber.
• The memory recall buttons show the names and states of the registers
corresponding to the selected bank.
Off: register in which nothing is saved
Lit orange: register holding shotbox settings
Lit yellow: last recalled register
2
Press the memory recall button to which the shotbox register you want to
run is allocated.
• The shotbox execution is carried out.
• The pressed button lights yellow.
• The numeric keypad control block [SHOTBOX] button lights, and the
region selection button corresponding to the region for which the effect
is set also lights.
• If the selected shotbox register has auto run set, on recall the effect is
immediately executed.
When auto run is not set for the recalled register
Simply recalling the register does not run the effect. To do this, press the
[RUN] button in the keyframe control block.
Executing a Shotbox Function With the Key 2 Row
Cross-Point Buttons
You can use the key 2 row of each of the M/E-1 to M/E-4, and PGM/PST banks
in the same way as the buttons in the utility/shotbox control block.
Notes
To use this function, it is first necessary to assign the utility shotbox mode
switching function to the control panel [PRE MCRO] button.
For details of the assignment operation, see “Assigning the Utility/Shotbox
Mode Switching Function” in Chapter 19 (Volume 3).
You can assign any shotbox register to the cross-point buttons.
For details of the assignment operation, see “Assigning a Function to the Key
2 Row Cross-Point Buttons” in Chapter 19 (Volume 3).
1
Press the [PRE MCRO] button, turning it on.
To Next Page
Loading...
Need help?
General