Chapter 16 Macros
950
Macro Attachment Assigning
Macro Attachment Assigning
Macro attachment is a function whereby a macro register is assigned to a
control panel button or a particular position of a fader lever, linking the
execution of the button function or a fader lever operation with a macro
execution.
Setting a macro attachment to a button
Select one of the following three linking modes to make the macro attachment.
Pre-macro: Mode in which the button function is executed after macro
execution has completed
Post-macro: Mode in which the macro is executed after carrying out the button
function
Macro only: Mode in which the button function is not executed, and the macro
only is executed
The selection of pre- or post-macro mode is carried out in the cross-point
control block of the PGM/PST bank or the M/E banks. For the macro-only
mode, assign the selection function to a utility/shotbox control block button or
user preference button, and make the selection by pressing the button.
Alternatively, without pressing the button, you can make the selection simply,
by simultaneously pressing the pre-macro and post-macro selection buttons in
the cross-point control block.
You can assign any one of the 250 macro registers to a button.
For a button whose function is switched by delegation, you can make a separate
macro attachment for each function.
For each control panel, you can make up to 1000 macro attachment settings.
The macro attachment setting is possible for the following bus buttons.
For button locations, see Chapter 2 “Menus and Control Panel” (Volume 1).
To Next Page
Loading...
Need help?
General