Chapter 19 Control Panel Setup (Panel)
1090
Overall Control Panel Settings (Config Menu)
For details of the operation, see the previous section “Linking Transitions
Between Keyers.”
2
Press [Next Trans Link], turning it on.
The [KEY1] to [KEY8] next transition selection buttons in the transition
control block are now selected coupled to the settings in the Key Trans
Link menu for transition links between keyers.
Notes
These settings apply to the whole Key Trans Link menu. It is not possible
to make separate settings for each master keyer.
Selecting the Module to be the Reference for Device
Control Block
When both trackball and joystick device control blocks are connected, select
which is to be the reference. Also select the range to which key wipe
positioning applies.
To select the reference module
1
In the Panel >Config menu, press [JS/TB User Setting].
The JS/TB User Setting menu appears.
2
In the <Reference Module> group, select one of the following.
Trackball: Trackball device control block
Joystick: Joystick device control block
To select the range to which key wipe positioning applies
In the Panel >Config menu <Wipe Pos Key Select Module> group, select one
of the following.
KEY1-4: Applies to keys 1 to 4.
KEY1-8: Applies to keys 1 to 8.
Notes
When “KEY1-8” is selected, after selecting more than one key it is not possible
to carry out key wipe positioning. There is no such restriction when “KEY1-4”
is selected.
To Next Page
Loading...
Need help?
General