Chapter 18 System Setup (System)
1062
Installation and Device Setup (Install/Unit Config Menu)
8
Press [Execute].
A confirmation message appears.
9
Press [Yes].
This carries out the installation, and when it completes normally, the
“Install” box shows “OK.”
Making Settings Required to Use the Software
To use the software listed below, you are required to enter an install key which
validates the software. (If the software has been factory installed, the install key
is not required.)
For the method of obtaining an install key, contact your Sony representative.
To obtain a key, you may be required to submit the unique device ID of the
switcher you are using. You can check the unique device ID in the Install/Unit
Config menu of the switcher, using the following procedure.
a) This can be used only on the MVE-8000A.
To display the unique device ID
1
In the System >Install/Unit Config menu, use either of the following
methods to select the device for which you want to register the license.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
2
Press [License].
The License menu appears as follows.
BZDM-9050 Texture Lighting Software (for MVE-9000)
BZS-8050
Editing Control Software
BZS-8200X Multi Program 2 Software
BZS-8420X
Color Corrector Software
BZS-8560X
Switcher Upgrade Software
BZDM-8560
DME Upgrade Software
a)
To Next Page
Loading...
Need help?
General
