Chapter 4 Keys
246
Key Setting Operations Using Menus
Specifying the Key Output Destination
Using the key processed keyer signals (external processed key)
To select the key processed keyer key fill and key source signals on the AUX
bus or edit preview bus, press [Ext Proc Key] turning it on, in the Processed
Key menu.
This assigns the key fill and key source signals for M/E-1 key 1 to reentry
signals PROC V and PROC K.
When a DME is selected on the keyer, the key fill and key source signals to
which a DME effect is applied are assigned.
Notes
You cannot select the PROC V and PROC K signals using the cross-point
selection buttons of the M/E or PGM/PST bank.
Using the key processed keyer signals or signals to which a DME
effect is applied in frame memory (frame memory feed)
To use the key processed keyer key fill and key source signals on the frame
memory source buses, in the Processed Key menu, press [FM Feed]. [Ext Proc
Key] turns on, and the key fill and key source signals processed on the
currently selected keyer are automatically assigned to frame memory source
buses 1 and 2. When a DME is selected on the keyer, the key fill and key source
signals to which a DME effect is applied are assigned.
Key Modify Clear
A simple button operation or a menu operation returns the key settings to the
initial status settings.
Press [Default Recall] at the lower left of the menu display, turning it on, then
press the corresponding VF button (VF1 to VF4) to return the key settings to
their initial status.
For details of the initial status, see “Selecting the State After Powering On
(Start Up Menu)” in Chapter 18 (Volume 3).
For the menu operation to return the key state to that set in initial status, see
“Returning to default state in function groupings” (page 128).
To Next Page
Loading...
Need help?
General