Chapter 20 Switcher Setup (Switcher)
1202
Settings Relating to Function Links (Link Menu)
To link the banks not only for transition execution but also for the
other operations
Press [Transition Only] and turn it off.
To release the link setting
Use the same operation as in step 2 to select the link number for which you
want to release the link setting, then press [Clear].
Making a Link Setting for Key Transition
You can make a link setting for key transition by using the Switcher >Link
>Key Transition Link menu.
The operations for which you can link two banks are the following independent
key transition operations.
• Auto transition
• Turning the key on or off
• Fader lever operation (on the downstream key control block)
1
In the Switcher >Link menu, press [Key Trans Link].
The Key Transition Link menu appears.
The status area displays a link list showing link sources and link
destinations, and a key selection list.
2
Using any of the following methods, select the link number you want to
set.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
3
In the <Key Select> group, select [Master Key] (link source).
4
Using any of the following, select the key you want to be the link source,
then press [Key Set].
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment Setting values
1 Link No Link number selection 1 to 32
Knob Parameter Adjustment Setting values
2 No Key number selection
1 to 40
a)
To Next Page
Loading...
Need help?
General