Chapter 8 Color Backgrounds, Copy and Swap, and Other Settings
442
Misc Menu Operations
For details, see “Interfacing With External Devices (Device Interface
Menu)” in Chapter 19 (Volume 3).
DME override
1
In the menu control block, press the top menu selection button [MISC],
then select VF1 ‘Enable’ and HF1 ‘Port Enable.’
The Misc >Enable >Port Enable menu appears.
2
In the <DME Override> group, select the DME override mode.
DME Override: When a switcher snapshot or effect using a DME is
recalled, forcibly select the DME that was used when saving.
On Air Protect: The operation is the same as the DME override function,
except that a DME being used by an M/E bank or P/P bank that is on
air will not be forcibly selected.
Notes
If effects using the same DME channel are selected simultaneously in two
or more regions, the DME is selected with the order of precedence P/P >M/
E1 >M/E2 >M/E3 >M/E4.
Enabling or disabling control from System Manager
By installing the BZPS-8000 System Management Software (System
Manager), you can use a computer connected on a network for management of
some switcher data and control operations.
To enable or disable this function, use the following procedure.
1
In the menu control block, press the top menu selection button [MISC],
then select VF1 ‘Enable’ and HF1 ‘Port Enable.’
The Misc >Enable >Port Enable menu appears.
2
Press [System Manager].
Each time you press the button toggles between enable and disable.
Editing Keyboard Settings
Notes
The following operations are only possible when a license for the BZS-8050
Editing Control Software is activated. For details of license registration, see
To Next Page
Loading...
Need help?
General