Chapter 4 Keys
239
Key Setting Operations Using Menus
Notes
If in the pattern selection described below you select “Mask Pattern,” and
“Box” for the main mask, the “Size” parameter here cannot be adjusted.
Set “Size” in the Main Mask menu.
3
To adjust the pattern and color, press [Zabton Adjust].
The Zabton Adjust menu appears.
4
In the <Zabton Pattern> group, select the pattern.
Key Wipe: Use a key wipe.
You can change this pattern by pressing [Pattern Select] to open the menu
for key wipe pattern selection (Pattern Select menu), and make
adjustments by pressing [Pattern Adjust] to open the menu for pattern
adjustment (Wipe Adjust menu).
Key Edge Pattern: Use a color mixing pattern for key edge.
You can change this pattern by pressing [Pattern Select] to open the menu
for edge color mix dedicated wipe pattern selection (Mix Pattern Select
menu), and make adjustments by pressing [Pattern Adjust] to open the
menu for pattern adjustment (Matte Adjust menu).
Mask Pattern: Use the main mask Box or Pattern.
You can also press [Pattern Select], and in the corresponding pattern
adjustment menu, change the pattern.
5
To adjust the color, press [Zabton Color] and adjust the following
parameters.
Masks
There are two masks, which can be used to mask off unneeded parts of a key
or background, or to remove defects, and these are known as the main mask and
subsidiary mask.
You can either use the main mask and subsidiary mask independently, or at the
same time.
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
4 Density Density 0.00 to 100.00
To Next Page
Loading...
Need help?
General