Chapter 7 Frame Memory
389
Still Image Operations
The current status of frame memory appears. (See page 384.)
2
From the pair selection buttons, press the buttons corresponding to FM1
and FM2.
This assigns the signals to FM1 and FM2.
To the right of the target FM selection buttons, the FM1 and FM2 output
status appears (see page 385).
3
If required, press [Pair], to select the FM operation mode (pair mode).
On: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) as a pair.
Off: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) individually.
For more details, see “Pair mode” (page 381).
Notes
In the Pair Recombination menu, the [Pair] operation is not possible.
4
Press the target FM selection button [FM1] or [FM2] (see page 385) to
select the FM operations apply to.
When [Pair] is On: Whichever of FM1 and FM2 you press, the pair is
selected.
When [Pair] is Off: One of the targets must be selected. However, in the
Clip >Play menu you can also select both FM1 and FM2.
Selecting a frame memory folder
Press a button in the frame memory folder selection area (see page 387).
By pressing [More] to switch the display, you can select from a maximum of
12 folders.
Thumbnails of the files within the selected folder appear.
Capturing and Saving an Input Image
As the input material for the frame memory, you can use the signal selected on
the frame memory source bus. For this signal you can use video processing
(video levels or hue value adjustment) or masking.
Allocating a frame memory source bus signal to one of FM1 to FM8, then
carrying out a freeze captures a still image in the corresponding frame memory
output image, and saves it in temporary memory.
For a freeze, an image can be captured either as video frame (a “frame freeze”)
or a video field (“field freeze”).
To Next Page
Loading...
Need help?
General