Chapter 6 DME Wipes
373
DME Wipe Pattern Operations in the Multifunction Flexi Pad Control Block
DME Wipe Pattern Operations in the
Multifunction Flexi Pad Control Block
Recalling a DME Wipe Snapshot
The operation of recalling a DME wipe snapshot in the Multifunction Flexi Pad
control block is the same as the operation of recalling a wipe snapshot, except
for pressing the [DME WIPE] button to select DME wipe snapshot mode.
See “Recalling a Wipe Snapshot” (page 330).
You can change the indications for buttons [0] to [9] in the memory recall
section to pattern images, using the Engineering Setup >Panel >Operation
>Flexi Pad Mode menu.
Selecting the DME Wipe Pattern
The operation of selecting the DME wipe pattern in the Multifunction Flexi
Pad control block is the same as the operation of selecting a wipe pattern,
except for pressing the [DME WIPE] button to select DME wipe snapshot
mode.
See “Selecting the Wipe Pattern” (page 331).
Note, however, that the pattern numbers for DME wipe patterns have four
digits.
To Next Page
Loading...
Need help?
General