Chapter 11 DME Operations
683
DME Special Effect Operations
a) The way in which the afterimage disappears is affected by both the Video Decay and
Decay Dust parameter adjustments for the motion decay.
Keyframe Strobe Settings
Notes
When you turn on keyframe strobe, if the Trail, Motion Decay or Wind effect
is on, it automatically goes off. (See “Note” in the section “Trail.”)
Leaving a trail of afterimages of the image
1
In the DME menu, select VF5 ‘Light/Trail’ and HF4 ‘KF Strobe.’
The KF Strobe menu appears.
2
Press [KF Strobe], turning it on.
This enables the Keyframe Strobe effect, and you can now use the knobs
to adjust the parameters.
3
Set the following parameter.
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the afterimage does not
decay.
4
To erase the afterimage, press [KF Strobe Eraser], turning it on.
Selecting the overlay priority for movie and still images (video
freeze image)
In the <Priority> group, select the way in which the images are overlaid.
Over: the movie is on top, and the still image is underneath.
Under: the movie is underneath, and the still image is on top.
2 Dust Soft Timing with which stardust
disappears
0.00 to 100.00
3 Dust Size Size of stardust 0.00 to 100.00
4 Dust Aspect Aspect ratio of stardust –100.00 to +100.00
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 Decay Degree of blurring of the video
signal
0.00 to 100.00
a)
To Next Page
Loading...
Need help?
General