Chapter 5 Wipes
319
Wipe Settings for Independent Key Transitions
Wipe Settings for Independent Key
Transitions
You carry out independent key transition wipe setting operations using the
Wipe Adjust menu for each keyer.
For an overview of independent key transitions, see “What is an independent
key transition?” (page 191).
This section describes the independent key transition wipe settings, taking the
M/E-1 >Key1 >Transition >Wipe Adjust menu as an example.
Basic Procedure for Independent Key Transition Wipe
Settings
Accessing the independent key transition wipe settings menu
As an example, to access the M/E-1 >Key1 >Transition >Wipe Adjust menu,
carry out the following operations.
• In the menu control block, select the top menu selection button [M/E 1] and
select VF1 ‘Key1’ and HF6 ‘Transition’ to display the Transition menu for
key 1, then press [Wipe Adjust].
If VF1 [Key5] is shown, press the switching button at the top of the menu, so
that [Key1-4] appears, and press VF1 [Key1].
Notes
To select [M/E-4], a previous assignment in the Setup menu is required.
• In the independent key transition control block of the M/E-1 bank, press the
key delegation button [KEY1], then press the independent key transition type
selection button [WIPE] twice in rapid succession.
Carrying out the above operation displays the M/E-1 >Key1 >Transition
>Wipe Adjust menu (which will be referred to below as simply the Key1 Wipe
Adjust menu).
Selecting the independent key transition wipe pattern
You select the independent key wipe pattern from the list of patterns displayed
in the menu.
To Next Page
Loading...
Need help?
General