Chapter 18 System Setup (System)
1060
Installation and Device Setup (Install/Unit Config Menu)
Installation and Device Setup (Install/Unit
Config Menu)
To install software or firmware in a device, use the System >Install/Unit
Config menu.
This installs the software and firmware in all devices (including the DCU)
connected to the Data LAN.
To display the Install/Unit Config menu
In the Engineering Setup menu, select VF1 ‘System’ and HF6 ‘Install/Unit
Config.’
The status area shows the version of the software and the firm ware installed in
each device.
The following functions are available here.
Install: Automatically detects the software that can be installed on each device,
and installs the selected software.
Detail Information: Gives details of the software and firmware installed in
each device.
Unit Config: Makes switcher processor settings and changes the DME input/
output signal format.
License: Makes the license valid or invalid.
Displaying installation details
In the System >Install/Unit Config menu, press [Detail Information].
This accesses the Detail Information menu, and displays the detailed
information on the software and firmware installed in the currently selected
device.
Installing Software
1
Insert the memory card holding the software into the memory card slot.
2
In the System >Install/Unit Config menu, press [Install].
The Install menu appears; the status area shows the following information.
Upper list: For each connected device, this shows the device name,
current software version (Current), and the latest version that can be
installed (Install, Title).
To Next Page
Loading...
Need help?
General