Chapter 23 Setup Relating to Router Interface and Tally (Router/Tally)
1259
Parallel Tally Settings (Parallel Tally Menu)
Parallel Tally Settings (Parallel Tally Menu)
For settings relating to parallel tally, use the Router/Tally >Parallel Tally
menu.
Make the parallel port settings for output of tally information pertaining to
sources and destinations.
For each of the tally output terminal numbers, specify the tally type, and source
address or destination level and address.
To display the Parallel Tally menu
In the Engineering Setup menu, select VF6 ‘Router/Tally’ and HF6 ‘Parallel
Tally.’
The status area shows the parallel tally settings.
Making or Modifying Parallel Tally Settings
1
In the <Device> group of the Router/Tally >Parallel Tally menu, select
DCU1 or DCU2.
2
Using any of the following methods, select the slot number and port
number.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
a) When the MKS-2700 is connected, select 2 for the slot and a value in the range 1 to 36 for
the port.
b) When the MKS-2700 is connected, select a value in the range 1 to 36.
3
Press [Set].
The Set menu appears.
4
In the <Source/Destination> group, select the tally type.
Src: Return a tally to all sources output to the destination.
Knob Parameter Adjustment Setting values
1 Slot No Parallel tally slot number
2 to 6
a)
2 Port No Parallel tally port number
1 to 54
b)
To Next Page
Loading...
Need help?
General