Chapter 19 Control Panel Setup (Panel)
1152
Operation Settings (Operation Menu)
– [TRANS PVW] button
– [UTIL] button
– [XPT HOLD] button in key rows
– Selection of signal assigned to the auxiliary bus control block key source
bus (either key signal only, or either video signal or key signal selectable)
• Sensitivity: Adjust trackball, joystick and double-click sensitivity, or set the
relationship between the angle of the search dial and the playback speed or
the sensitivity for the search dial in jog mode.
• Main Split Fader: When the split fader is active, specify whether the fader
to control other than mix is the left side or the right side.
• Macro: Set the macro execution mode and the mode in which to edit macros
using the standard type Flexi Pad control block.
Setting the On-Air Tally
To set the high tally state reflected on the control panel, use the following
procedure.
1
In the Panel >Operation menu, press [Button Tally].
The Button Tally menu appears.
2
In the <Tally Type> group, select either of the following.
[R1] to [R8]: Reflect any of tally groups 1 to 8 as the tally state.
Independent: Reflect only the switcher tally state.
3
Press [Execute].
A popup window appears and shows the progress of the operation.
Setting the Transition Rate Display Mode
To determine whether to display transition rate values in menus and on the
control panel in frames or as timecode values, select either of the following in
the <Trans Rate Display> group.
Frame: display in frames.
Timecode: display as timecode (SS:FF).
To Next Page
Loading...
Need help?
General