To Next Page

To Previous Page

Chapter 6 DME Wipes

366

DME Wipe Snapshots

You can snapshot and save a DME wipe pattern together with the current

settings of its modifiers and pattern limit in a dedicated register for recall when

required.

There are 10 DME wipe snapshot registers for each of the M/E and P/P banks.

To save and recall these registers, use the Flexi Pad control block, the

Multifunction Flexi Pad block in each switcher bank or the Menu control

block.

In the case of a simple transition system, there are eight DME wipe snapshot

registers for each switcher bank.

DME Wipe Snapshot Operations With the Flexi Pad

To carry out DME wipe snapshot operations, use the Flexi Pad control block.

You can save, recall and delete DME wipe snapshots using the procedures

similar to the procedures for wipe snapshot operations. In DME wipe snapshot

operations, use the [DME] button instead of the [WIPE] button used in wipe

snapshot operations.

Selecting a DME wipe pattern in the Flexi Pad control block

In the standard type Flexi Pad control block, enter a four-digit pattern number,

using the [DME] button.

For details, see “Flexi Pad Control Block (Standard Type)” (page 63).

Notes

• You cannot select a DME wipe pattern in the simple type Flexi Pad control

block.

• A button in the memory recall section in which a DME wipe snapshot is

saved shows the pattern, and lights yellow.

For a user-programmable DME, the register number (see page 368) appears.

Depending on the setting of the Setup menu (see “Operation Settings

(Operation Menu)” in Chapter 19 (Volume 3)), you can also display a

• In a simple type Flexi Pad control block, it is not possible to delete a DME

wipe snapshot.

For details of the operating procedures, see “Wipe Snapshots” (page 324).

Sony MVS -8000X User Manual

Other manuals for Sony MVS -8000X