Chapter 16 Macros
930
Macro Operations in the Simple Type Flexi Pad Control Block
Press the button to restart macro execution.
Executing a macro in step execution mode
After recalling the macro register, to execute a macro in step execution mode,
use the following procedure.
Notes
To execute a macro in step execution mode requires setting the step execution
mode in the Setup menu.
For details of the method of setting, see “Setting the Macro Execution Mode”
in Chapter 19 (Volume 3).
1
In the simple type Flexi Pad control block, press the [MCRO] button,
turning it on.
This assigns the Flexi Pad control block to macro operation.
2
Press the button in the memory recall section showing the register to be
recalled.
3
Press the [Take] button.
This executes one event within the macro, then stops.
The number of events executed, as shown in the memory recall section
status display, is incremented by one.
4
Repeat step 3, executing the macro event by event.
When all events in the macro have been executed, the [Take] button goes
off.
Creating and Editing a Macro
Creating a macro
1
In the simple type Flexi Pad control block, press the [MCRO] button,
turning it on.
This assigns the Flexi Pad control block to macro operation.
2
While holding down the [MCRO] button in the Flexi Pad control block,
press the button in the memory recall section showing the desired register
name.
To Next Page
Loading...
Need help?
General