Chapter 11 DME Operations
684
DME Special Effect Operations
Mix: the movie and still images are mixed; adjust the following parameter with
the knob.
a) The 0.00 setting is the same as Over, and the 100.00 is the same as Under.
Selecting the freeze timing
In the <KF Freeze Timing> group, select the timing for freezing the keyframe
strobe.
Frame: freeze in frame units.
Field: freeze in field units.
Notes
The freeze timing setting is not required when the following signal formats are
being used.
Signal formats: 1080P/50, 1080P/59.94, 1080PsF/23.976, 1080PsF/24,
1080PsF/25, 1080PsF/29.97, 720P/50, 720P/59.94
Erasing the afterimages that remain in memory whenever a
keyframe is passed
Press [KF Strobe Eraser], turning it on.
When the effect passes a keyframe, the afterimage is erased before writing a
new afterimage.
Applying stardust to the afterimage portion
The afterimage portion becomes stardust, and gradually disappears.
1
Press the [DUST] button, turning it on.
2
Set the following parameters.
Knob Parameter Adjustment Setting values
1 Mix Mix amount of the still image with
respect to the movie
0.00 to 100.00
a)
Knob Parameter Adjustment Setting values
1 KF Strobe
Dust
Amount of the afterimage
disappearing as stardust
a)
0.00 to 100.00
2 Dust Soft Timing with which stardust
disappears
0.00 to 100.00
3 Dust Size Size of stardust 0.00 to 100.00
4 Dust Aspect Aspect ratio of stardust –100.00 to +100.00
To Next Page
Loading...
Need help?
General