Chapter 18 System Setup (System)
1071
Installation and Device Setup (Install/Unit Config Menu)
The Install/Unit Config menu appears; the status area shows the version
information for the software installed on the various devices.
3
Press [Install].
The System >Install/Unit Config >Install menu appears; the status area
shows the following information.
Upper list: For each connected device, this shows the device name,
current software version (Current), and the information about the
texture package that can be installed (Install, Title).
OK: Installation already completed.
On: For installation, but not completed.
Error: An error occurred during installation.
Cancel: Installation canceled.
Lower list: For the device selected in the upper list, this shows an
automatically detected list of software that can be installed on the
particular device. Also, software selected as a candidate for
installation in the upper list is marked in the lower list with an asterisk.
4
Using any of the following methods, select in the upper list a DME for
which the spotlighting license is valid.
• Press directly on the list in the status area.
• Use the arrow keys to scroll the reverse video cursor.
• Turn the knob.
5
Press [Display All Software], turning it on.
The lower list shows the texture packages.
6
Using any of the following methods, select the texture package you want
to install from the lower list.
• Press directly on the list in the status area.
• Use the arrow keys to scroll the reverse video cursor.
• Turn the knob.
7
Press [Set].
The selection is reflected under “Install” and “Title” in the upper list.
Knob Parameter Adjustment Setting values
1 Device Device selection 1 and upwards
Knob Parameter Adjustment Setting values
3 No Package selection 1 and upwards
To Next Page
Loading...
Need help?
General