Chapter 14 Snapshots
877
Snapshot Operations in the Menus
5
Press the button for the number or name you want to save.
This saves the snapshot, and the button goes off.
Changing the bank
Change the combination shown on the memory recall buttons (the bank).
1
Press [Bank Sel].
2
Select the bank in the numeric keypad window.
For example, to show the numbers or names corresponding to registers 11
to 20, select “1” in the numeric keypad window.
Applying attributes
To apply an attribute to the snapshot represented by a lit-green memory recall
button, use the following procedure.
1
To apply the cross-poi
nt hold attribute, in the <Attribute Xpt Hol
d> group
select the appropriate bus.
Notes
A setting in the Setup menu determines whether key disable is applied to
cross-point hold or not. For details, see “Setting the Operation Mode of the
Key Bus [XPT HOLD] Button” in Chapter 20 (Volume 3).
2
Select the followin
g attributes in the <Attribute> group as requir
ed.
Effect Dissolve: Apply effect dissolve.
Auto Transition: Apply auto transition.
GPI Output: Apply GPI output. When this is selected, select the GPI
number with the knob.
Deleting a snapshot
1
In the Misc >Snapshot menu, press [Delete].
The button lights amber.
2
As required, change the bank.
3
Press the button for the number or name you want to delete.
This deletes the snapshot, and the button you pressed goes off.
To Next Page
Loading...
Need help?
General