Chapter 17 Files
987
Operations on Individual Files
• To select all files within the list, press [ALL] below the list.
• To select multiple files, turn the knobs to select in the following ranges.
• To select a single file, press the arrow keys to scroll the reverse video
cursor, or press directly on the list in the status area.
5
Press [t Save].
This saves the selected register data in the specified location.
If there is already data in the specified location, a confirmation message
appears.
• Select “Yes” to overwrite the data.
• Select “No” to cancel saving all of the data.
Saving frame memory files
Notes
When the signal format is 1080P, saving a still image file creates two still
image files for each frame. An ‘A’ is automatically appended to the first file
name, and a ‘B’ is appended to the second file name. If either of these files is
missing, it is not possible to recreate the image, and therefore for correct
operation the two files must always be handled together.
Between steps 3 and 4 of the procedure above, “Saving Files,” do as follows.
1
To select the frame memory folder, press [Default] in the device selection
in the list on the left.
A pull-down menu appears.
2
Press the required folder name.
3
Carry out the same operations as in steps 1 and 2 on the list on the right.
4
Select the type of data to be displayed.
• To display still image files, press [Still].
• To display clip files, press [Clip].
• To display extended clip files, press [Ext Clip].
Knob Parameter Adjustment Setting values
1 List L Select the first register whose data is to
be saved
1 to 99
2 List R Select the first file to which data is to be
saved
1 to 99
3 Num Number of registers to be selected 1 to 99
To Next Page
Loading...
Need help?
General