To Next Page

To Previous Page

System Setup

Instructions for Use Apollo SW 4.5n 73

Part Number: 9053586, 3rd edition

Connecting the passive scavenger sys-

tem (Optional)

Figure 28. Passive Scavenger SystemThe passive scavenger system is used only with non-

recirculating exhaust systems. It is not meant to be

used with vacuum disposal systems.

1. Install the passive scavenger on the machine by

sliding its bracket onto the two shoulder screws

on the side of the machine.

Note: Remove the socket from the scavenger hose

before connecting.

2. Connect one end of the transfer hose to the side

fitting on the scavenger (1 in Figure 28).

3. Connect the other end of the transfer hose to the

scavenger connection on the back of the

anesthesia machine (2 in Figure 28).

4. Connect the waste-gas hose to the bottom

connection on the scavenger (3 in Figure 28).

5. Connect the other end of the hose to the hospital

waste-gas disposal system.

6. Make sure that the passive scavenger system is

ready for operation.

For detailed information on the passive scavenger

system, refer to separate Instructions for Use.

CAUTION!

Risk of increased ambient gas concentration

Ambient air may become contaminated with

anesthetic agent if the scavenger hoses are

functionally inhibited.

The scavenger hoses must not be pinched, kinked,

or blocked in any manner.

Dräger Apollo User Manual

Other manuals for Dräger Apollo