Features List
155
[F Code]
When a folder is set on a remote device, you can send a document directly to the folder by
specifying the F code (sub-address) and password (if set up) of the folder.
Obtain the F code (sub-address) and password of the remote folder in advance.
Example of specifying a destination:
F Code (sub-address): 0 (to designate an F Code transmission) and the folder number of a
folder on the remote device
Password (if set up): The password of the remote folder
When this feature is enabled, you can set the F code and password of the remote folder.
[Remote Polling]
Remote Polling is a feature that allows your device to retrieve a file stored in a remote
device.
The Remote Polling feature may not be available depending on the remote device.
To use Multi-Polling, specify multiple recipients.
[On-hook (Manual Send/Receive)]
Use this feature when using Manual Send.
Manual Send is the transmission method that allows you to send a fax after you make a
phone call to a remote device and then check that the connection is established. This
feature can be used with the receiver either off-hook or on-hook.
If an error occurs during transmission of, for example, the second page, the transmission of the first page
may also end abnormally.
[Chain Dial]
Allows you to combine the fax numbers registered with the Address Book and the numbers
entered through the touch screen to specify as one recipient.
For information on the display of the Chain Dial, refer to "[Chain Dial]" (P.283).
[Internet Fax Subject]
You can specify an Internet Fax subject.
If no subject is entered, the automatically set subject will be "InternetFAX;<From> ; <Send Date and Time>".
[Internet Fax Message]
You can edit Internet Fax comments.
To Next Page
Loading...
Need help?
General
