12 General Settings
244
[Non-Genuine Toner / Drum Cartridge]
Set this feature when using device in the custom mode.
Use with supported toner and drum.
Using this setting may not maintain the device’s sufficient feature and performance, and we do not certify
the performance. Keeping using the non-genuine product may put the device out of order and you are liable
for the cost of repairs.
When you select [Yes], the toner and drum cartridge remaining are not displayed.
[Image Quality]
[Adjust Paper Registration]
Allows you to make an adjustment to match the positions of the images with paper.
For detailed procedure, refer to "Adjust Paper Registration" (P.410).
[Calibration]
When color gradation of a printed image shifts, you can calibrate the color of the image to
maintain the image quality of the device at a certain level.
If you cannot calibrate the device to adjust for a shift in color gradation despite the periodic calibration,
contact our Customer Support Center.
For more information, refer to "Executing Calibration" (P.406).
[NVM Read / Write]
Adjusts the device operations.
[Altitude Settings]
Set the altitude of the place the device is located.
Setting the correct altitude helps the device to secure the print quality and display the
accurate remaining amount of toners.
[Adjust Fusing Temperature]
Adjusts the fusing temperature per paper type.
The separation of an image or curl of paper, which occurs depending on the paper type or
environment, may improve owing to the fusing temperature adjustment.
[Process Control Setup]
Adjusts the toner density automatically.
Perform this feature such as when you find any toner density disorder or you need to print
more accurate.
To Next Page
Loading...
Need help?
General
