[System Settings]
249
[System Settings]
[System Clock / Timers]
You can set the system clock or the time intervals of the device to reset settings.
[Date]
Set the date in the system clock of the device.
[Time]
Set the time in the system clock of the device.
[NTP Time Synchronization]
Gets time from server so that it syncs with the time server (NTP) and match the time to the
device.
[Connection Interval]
Select the time interval to connect to the time server.
[Time Server Address]
Set the server name or IP address of the time server.
[Auto Clear]
Specify the time lapsed without any operation until the device resets the settings.
Even when set to [Off], if one minute has elapsed after reading the original but no job starts, the device will
cancel the standby status and begin processing the original.
[Auto Job Release]
Specify the time lapsed until the device cancels the active job and starts the next job if an
error such as document or paper jams and running out of paper occurs during copying or
scanning.
[Auto Print]
Set the time lapsed until the device becomes available to make printing after the last
operation on the control panel (except for [Start]).
[Printer Lockout]
Sets to temporarily prohibit printing.
Select [Allow User to Lock Out] to display [Auto Printing].
Tap [Auto Printing] on the Home screen to open the popup screen. You can temporarily
block printing by selecting [Disabled]. Selecting [Enabled] allows you to release printing.
You also can set to prohibit printing at a certain time. For details, refer to the CentreWare Internet Services
help.
When [Don't Allow User to Lock Out] is selected, [Auto Printing] is not shown on the Home screen.
To Next Page
Loading...
Need help?
General
