[Maintenance]
245
[Ink Setoff Prevention]
Set whether or not to activate the function to prevent the adhesion of sheets of paper.
[Copy Image Quality]
Set how much to reduce the roughness of the copied image.
[Coated Paper Print Mode]
Set whether to focus more on the speed or the image quality on the printing.
[Clean Developer Unit and Transfer Module]
After the device has been remained with powered on but not perform printing for a certain
period, the background of the print result may have some unwanted colored parts. To
improve this fault, clean the Developer Unit and the Transfer Module.
[Toner Density Settings]
Adjusts the amount of toner to consume when printing. Reducing the density saves toners
and increasing makes the printed image clearer.
[Refresh Toner]
Re-adjusts the toner density and the developer voltage. Refreshing toners optimizes the
print quality.
Do not perform Refresh Toner too many times as the toner would decrease at a fast pace.
[Clean Transfer Belt]
If dust stick to the Transfer Belt, the black or colored vertical stripes or lines may appear on
the printed image. To improve this fault, clean the Transfer Belt.
[Primary Transfer Current Adjustment]
Adjusts the transfer voltage of the black toner and color toner when a poor transfer due to
paper type or environment causes missing a part of image.
[2 Sided Color Scanning Calibration]
When the image is color scanned by the duplex automatic document feeder, you can
calibrate the color of the image on 2 sided side 1 and side 2.
For more information, refer to "Executing 2 Sided Color Scanning Calibration" (P.408).
[Adjust Color Registration]
You can adjust color registration if colors are misaligned in outputs.
Do not execute color registration continuously. Doing so may impair the performance of the device.
To Next Page
Loading...
Need help?
General
