12 General Settings
242
[Accounting Report (Print Jobs)]
You can check the total number of printed pages and sheets of paper, used for each client
(job owner). [Accounting Report (Print Jobs)] counts pages from the time at which the data
is initialized.
When [Print Jobs] is set to [Disable Accounting] in [Accounting Mode] under [Accounting Type], [Meter Report
(Print Jobs)] is displayed instead of [Accounting Report (Print Jobs)]. For more information, refer to "[Meter
Report (Print Jobs) ]" (P.241).
[No.] displayed on the report is the User Administration Number assigned when a user is registered under
[Accounting] or [Authentication / Security Settings].
[Accounting Report (Scan Jobs)]
You can check the total number of pages scanned on the device. If the number of pages
that can be scanned have a limit, you can also check the limit value. [Accounting Report
(Scan Jobs)] counts pages from the time at which the data is initialized.
[No.] displayed on the report is the User Administration Number assigned when a user is registered under
[Accounting] or [Authentication / Security Settings].
[Accounting Report (Fax Jobs)]
You can check the total number of fax transmissions/receptions and the total number of
pages transmitted for each user.
[No.] displayed on the report is the User Administration Number assigned when a user is registered under
[Accounting] or [Authentication / Security Settings].
[EP Diag/Repair Request]
When the EP system via the Internet is used, the device contacts our Customer Support
Center if a check or maintenance is required.
For information on the EP system, refer to "EP System" (P.512).
[EP Registration]
For information on the EP system, refer to "EP System" (P.512).
[BB Registration]
Select [BB Registration] and then select [Start] to register the device in EP system.
[EPA Server Registration]
After the BB registration, [EPA Server Registration] is automatically selected in accordance
with your environment. When this feature is selected, enter the destination server IP of your
EPA server and then select [Start] to register the device in the EPA server.
[Quick Setup Home]
Allows you to check if the initial settings to use the device have completed. To set up the
items not set yet, you can open the setting page through this screen.
To Next Page
Loading...
Need help?
General
