Configuration to Use Device Setup Tool
203
Configuration to Use Device Setup Tool
To create the job flow sheets using Device Setup Tool, the following settings are required.
TCP/IP address settings
Enabling SOAP port
Configuring SNMP port
Installing Software
For information on how to set a TCP/IP address, refer to "Setting the IP address" (P.36).
For information on the software installation, refer to "Overview of Job Flow Sheets" (P.196).
Enabling SOAP Port
1
Log in to the System Administration mode.
For more information, refer to "Login to Authentication Mode" (P.77).
2
Tap [Device] on the Home screen.
3
Tap [Connectivity & Network Setup] > [Port Settings] > [SOAP] > [Port Status].
4
Tap [Enabled].
5
Press the Home button.
Rebooting the device is required to enable the settings. Reboot the device following the message on the
screen.
Configuring the SNMP Port
Configure the transport protocol for the SNMP port using CentreWare Internet Services.
1
Start CentreWare Internet Services.
For more information, refer to "Starting CentreWare Internet Services" (P.85).
2
Log in to the System Administration mode.
3
Click [Network] on the left menu.
4
Click [SNMP], and then select the [Port] check box.
5
Select the [Authentication Failure Generic Traps] check box.
6
Click [Save].
Rebooting the device is required to enable the settings. Reboot the device following the message on the
screen.
To Next Page
Loading...
Need help?
General
