GE PROPRIETARY TO GE
D
IRECTION 5308917-100, REVISION 8 LOGIQ P3 SERVICE MANUAL
8-2 Section 8-2 - Disassembly/Re-assembly of LOGIQ P3
Section 8-2
Disassembly/Re-assembly of LOGIQ P3
8-2-1 Warning and Caution
8-2-2 Returning/Shipping for repairs
Equipment being returned must be clean, free of blood and other infectious substances.
GE policy states that body fluids must be properly removed from every part or equipment prior to
shipment. GE employees, as well as customers, are responsible for ensuring that parts/equipment have
been decontaminated prior to shipment. Under no circumstances should a part or equipment with visible
fluids be taken or shipped from a clinic or site (For example: body coils or an ultrasound probe). The
purpose of the regulation is to protect employees in the transportation industry, as well as the people
who receives or opens the package.
NOTE: The US Department of Transportation (DOT) has ruled that “items that were saturated and/or
dripping with human blood that are now caked with dried blood; or which were used or intended
to use in patient care” are “regulated medical waste” for transportation purposes and must be
transported as a hazardous material.
8-12
Signal Cable Set (FRU P/N: 5315042 for P3 and P/N:
5388847 for P3 BT)
8-87
8-13
Power Cable Set (FRU P/N: 5315036 for P3 and P/N:
5388845 for P3 BT)
8-89
8-14
Loading Software
8-93
ONLY QUALIFIED SERVICE PERSONNEL SHOULD REMOVE ANY COVERS OR
PANELS. ELECTRICAL HAZARDS EXISTS AT SEVERAL POINTS INSIDE. BECOME
THOROUGHLY FAMILIAR WITH ALL HAZARDOUS VOLTAGES AND HIGH CURRENT
LEVELS TO AVOID ACCIDENTAL CONTACT
Do not wear the ESD wrist strap when you remove a part of power supply unit. Turn OFF power
and unplug the power cord before removing a part of power supply unit.
Contents in Chapter 8
Section Description Page Number
To Next Page
Loading...
Need help?
General
