IBM SAN Volume Controller 2145-CG8 User Manual

5. Use a small screwdriver to gently press the release button and release the catch while pulling gently
forward on the service controller. The service controller will move slightly forward.
Note: If you meet any resistance, do not press harder, or you might damage the release mechanism.
6. You can stop pressing the release button and pull the service controller fully out of the frame, as
shown in Figure 81
Note: When you replace a service controller, it is normal to change the worldwide node name
(WWNN) of the new service controller to match the one that is being replaced. In this case, you will
have two service controllers with the same WWNN. Clearly label the service controller that you are
removing and indicate that its WWNN is now a duplicate and that it must not be connected to a SAN
before its WWNN is reset.
svc00416
Figure 80. SAN Volume Controller 2145-8G4 service controller release button
svc00245
Figure 81. Removing the service controller from the SAN Volume Controller 2145-8G4
Chapter 2. Removing and replacing parts 93

IBM SAN Volume Controller 2145-CG8 Specifications

General

Brand	IBM
Model	SAN Volume Controller 2145-CG8
Category	Storage
Language	English